Where do I adjust printing parameters for hardcopy printouts?

[Kenneth Brody]

Quoting fp (Wed, 15 Aug 2007 13:23:12 -0700):

> Boaz asked:
>
>>
>> If I want to print out a hardcopy of a processing table after exiting
>> rcabe, the current setup prints out 66 lines per page.  Where can I go
>> to change the set-up for this?
>>
>
> Any hard copy not controlled by processing will print to your set default
> printer.
>
> There a several ways to find your default printer:
[...]

Don't forget about the "-p" series of flags to override the default.

> It might be worth mentioning that changing this printer may cause other
> problems with reports that are currently printing to that printer and page
> settings (lines per page) are just fine - In other words, you may cause
> these reports to run off line or start printing out of alignment.

You can always copy the table you want and change the paper size and any
init/end codes as needed, and use "-pc" to use that printer definition.

For example, you might copy "fooprinter" to "fooprinter-132" and change
the settings to get it to print 132 columns of condensed text.

-- 
KenBrody at BestWeb dot net        spamtrap: <g8ymh8uf001 at sneakemail.com>
http://www.hvcomputer.com
http://www.fileProPlus.com