Printing Landscape & from 2nd tray on XEROX Multi Function Printer/Copier

[Jose Lerebours]

Mike,

No, F8 and O only shows printer code ( 13 ) on start and there is no 
print code embedded within the form itself.

Thanks,


Jose


On 01/28/2016 12:52 PM, Mike Schwartz via Filepro-list wrote:
>> The problem:
>> - Using OpenSuSe Linux
>> - Printing to Xerox Multi Function Printer
>> - Set in filePro as hp-5 printer type
>> - Using lp -d[printer-name] -o landscape -o x17 in printer configuration
> table
>> - filePro 5.08
>>
>> If I use the same command as above, it print landscape and it pulls paper
>> from 2nd tray (11x17).
>> If I print from Yast printer configuration, it prints from 2nd tray as it
> is
>> configured to If I print from filePro, it prints landscape but from 8.5x11
>> (possibly tray 1 ...)
>>
>> If printing from OS command line prints proper orientation and from
>> expected tray, why doe it not do same from filePro?
>>
>> No print codes other than ( 13 ) to set pitch and ( 13 ) does not have
> anything
>> but setting the pitch.  Tried without the printer code ( 13 ) and it still
> prints
>> from 8.5x11 tray, it prints in landscape but bigger letters.
>>
>> Your assistance in this matter will be appreciated!
>>
>> Regards,
>>
>> Jose Lerebours
>> 954 559 7186
>       Is the printer config from filePro set to send a "reset printer" to the
> printer before each print job?  You have to look on the printer defaults
> page to see that.
>
> Mike Schwartz
>
>
> _______________________________________________
> Filepro-list mailing list
> Filepro-list at lists.celestial.com
> Subscribe/Unsubscribe/Subscription Changes
> http://mailman.celestial.com/mailman/listinfo/filepro-list