Output no matter what's happening (-RO not Working)

[Richard D. Williams]

Top Post:

Mike,

You have changed this thread so it is coming from 
filepro-list at lists.celestial.com.

I have files with millions of records and there is no limit associated 
with the -RO flag.

If you want, attach you code on a reply and I will review it.

I am sure the issue is code oriented. Sometimes a fresh pair of eyes is 
a good thing.

Richard


On 7/31/2014 6:02 PM, FilePro List wrote:
> Geez, I have no idea if this is even going to get to the list cause I
> just got a message saying this...
>
> Your membership in the mailing list Filepro-list has been disabled due
> to excessive bounces The last bounce received from you was dated
> 31-Jul-2014.  You will not get any more messages from this list until
> you re-enable your membership.  You will receive 3 more reminders like
> this before your membership in the list is deleted.
>
>
> Anyhow, I changed the output line to say this and it took a whole three
> seconds to run through every record without any issues.
>
> \fp\dreport invy -f expIslk -y none -z none -a -u -ro
>
>
> There's not much processing going on here and without the -ro flag it
> only takes about 15 seconds to run
>
>
> Mike
>
>
>
> On 7/31/2014 5:35 PM, Kenneth Brody wrote:
>> On 7/31/2014 5:11 PM, FilePro List wrote:
>>> After watching it again, the output starts out okay when using the -RO
>>> flag but then just starts slowing way down until it just stops all
>>> together. There are 49619 records in the file and it stops on 36128
>>> every time. I wouldn't think there would be a limit on the number of
>>> output records when using the -RO flag.
>> There isn't any limit to the number of records, beyond the filePro
>> limit of 2 billion records per file.  The -RO flag has no effect on this.
>>
>> You say this is in the output phase.  As a quick test, run the report
>> without any processing ("-y none -z none") and see if this makes a
>> difference.  If so, then there's probably something that your
>> processing is doing, perhaps a getnext loop, which is causing the
>> problem.
>>
>>> This is the command line and the output is on about 45,000 records but
>>> it hangs on 36,000 or so every time I try running it and the file is not
>>> locked, nobody is using the computer other than me when I tried it.
>>>
>>> \fp\dreport invy -f expIslk -a -RO -u
>>>
>>> Filepro 5.0.09 (DN9 whatever that means)
>> The "DN9" means:
>>
>>      "D" - dreport, rather than rreport.
>>      "N" - the "network aware" version, because long ago where was
>>            an MS-DOS version which wasn't.
>>      "9" - the Windows native version, again to distinguish it from
>>            one of the no-longer-available MS-DOS versions.
>>
>> [...]
>>
> _______________________________________________
> Filepro-list mailing list
> Filepro-list at lists.celestial.com
> Subscribe/Unsubscribe/Subscription Changes
> http://mailman.celestial.com/mailman/listinfo/filepro-list
>
>
>