Can I use "getnext -" in dclerk?

Jay Ashworth jra at baylink.com
Fri Apr 5 09:28:04 PDT 2013


----- Original Message -----
> From: "Richard Kreiss" <rkreiss at gccconsulting.net>

> > See my reply to Ken, but the salient point is: I didn't use "lookup
> > -" to get where I am.

> Sounds you need a new system variable @ix which would contain the
> value of the index selected for IUA. Then you could use that value for
> a lookup - and getnext.

Well, in this particular case, I know which index I used, so I suppose I 
could in fact hard-wire the lookup -, now that you suggest that.  I think
newer versions actually tell you which index is active in a sysvar, but
alas, this site's on 4.8, and I don't know that I can sell an upgrade at 
the moment.

And in practice, I've never recommended that my clients upgrade past
5.0.14 anyway, for reasons that are intuitively obvious to the most
casual observer who's ever been locked out of their software at 0330 
on a Sunday morning.

Cheers,
-- jra
-- 
Jay R. Ashworth                  Baylink                       jra at baylink.com
Designer                     The Things I Think                       RFC 2100
Ashworth & Associates     http://baylink.pitas.com         2000 Land Rover DII
St Petersburg FL USA               #natog                      +1 727 647 1274


More information about the Filepro-list mailing list