show only browse
Bruce Easton
bruce at stn.com
Thu Sep 16 14:31:13 PDT 2010
On 9/16/10 5:14 PM, Kenneth Brody wrote:
> On 9/16/2010 5:07 PM, Richard Kreiss wrote:
>> Correction on my post:
>>
>> Programming worked with the debugger on but not with it off.
>>
>> At Ken's urging, I looked at this again to see if there was a simpler
>> solution. There was using John's suggestion of @entsel processing.
>>
>> I declared a variable atkeyf9(1,.0,g) in input processing. When the @key9
>> processing runs, I set atkeyf9 = "9". I needed to add SHOW"@" after the
>> browse command to keep it up.
>>
>> When<enter> is pressed, @entsel processing checks:
>>
>> If: atkeyf9="9"
>> Then: switchto (sn);atkeyf9="";end
>>
>> This does work and is not as complex as I had made it.
> [...]
>
> And is probably still more complex than you need. Why don't you just do
> everything in the @key9 processing?
>
As in, go back to my example which is not quoted here and use it.
Bruce
Bruce Easton
STN, Inc.
More information about the Filepro-list
mailing list