Linux - perfect replacement for desktops

Brian K. White brian at aljex.com
Sun Jul 29 19:28:49 PDT 2007


----- Original Message ----- 
From: "Tom Aldridge" <toma at aldridgeinc.com>
To: <brian at aljex.com>
Sent: Sunday, July 29, 2007 1:48 PM
Subject: Re: Linux - perfect replacement for desktops


> On Sat, 28 Jul 2007 05:34:31, Brian K. White helped Tom Aldridge as 
> follows:
>
> > Lucky you, this is a piece of cake. :)
> >
> > Gnome-terminal will work fine, as can kde's terminal as can rxvt as
> can the stock xterm.
> > They all require slightly different handling vis-a-vis their own
> config and the fp termcap file, but there is no problem.
>
> Brian,
>
> Thanks so much! No more (cosmetic) destructive cursor! Simply not setting 
> term before starting filePro, using the xterm command string you gave and 
> copying the xterm termcap, worked great! One thing, how does one change 
> ESC ESC for Save to F11 as my users are accustomed to that? I see with the 
> vt102 I changed :L4=F11, but in the xterm termcap L4 already is F11. Is 
> the save key a different code in the xterm termcap?
>
> Tom

My pleasure.

L4 is just a label. P4 is the corresponding definition of actual bytes you 
want fp to recognize.

The xterm definition I supplied takes advatage of the fact that xterm is 
only a little different from the linux console, and so only defines those 
bits that are different and then references linux for the rest. ":tc=linux:" 
basically means "find the definition for linux elsewhere in this file and 
include it here"

So, if you want the change to affect both the console and the xterms (and 
anyone telnetting/sshing in using a linux terminal emulator) then change the 
L4 and P4 definitions in the linux entry.

If you just want to change the xterm, then insert L4 and P4 definitions in 
the xterm definition, anywhere before the tc=linux. tc-linux must remain the 
last item.

For L4, since it's just a label, you can put whatever you want. :L4=F11: is 
fine
For P4 (or any other P*) if you want it to be F11, then while logged in in a 
gnome-terminal at a command prompt, press, ctrl-v, then pres F11, it will 
show you what the bytes were that the F11 key sent instead of interpreting 
and acting on them normally. then make P4= that string. Under xterm, this 
comes out as "^[[23~"

The ^[ part is an escape character, and termcap does know how to interpret 
this string just as is, it knows ^[, \E, \033, \0x1b I think, and a raw 
actual escape character even, but for several indirect reasons it's best to 
only use \E
so put P4=\E[23~

Brian K. White    brian at aljex.com    http://www.myspace.com/KEYofR
+++++[>+++[>+++++>+++++++<<-]<-]>>+.>.+++++.+++++++.-.[>+<---]>++.
filePro  BBx    Linux  SCO  FreeBSD    #callahans  Satriani  Filk!



More information about the Filepro-list mailing list