Envelope printer suggestions?
Jay R. Ashworth
jra at baylink.com
Thu Jul 19 15:19:19 PDT 2007
On Thu, Jul 19, 2007 at 04:57:57PM -0400, Fairlight wrote:
> > They also said that the laser printer shouldn't be plugged into a surge
> > protector because that could somehow provide less electricity than just
> > plugging it into the wall. More news.
>
> Sha, right. *snickers* They're right--IF your wall outlet is running -so-
> hot that your UPS has to actually regulate the power downwards continuously
> because it's running in a state of near-constant "surge". A proper UPS
> like an APC conditions the power flow and makes sure it goes neither two
> high nor too low. Well, okay, I see a difference in terminology here--you
> said specifically surge protector, I'm talking UPS. A flat surge protector
> won't regulate the power, it'll just suppress surges and spikes. There is
> the possibility that there could be a resistance factor in a passive surge
> protector, but I think it would be -so- minimal that they're still talking
> about something that's unlikely. If there's doubt, get a power-regulating
> UPS like an APC, which regulates and conditions the power flow 100% of the
> time.
In my experience, laser printers shouldn't be plugged into *UPSs*,
because the motor and heater spikes can damage the inverter output
transistors. You might assume that transfer (rather than continuous)
UPSs wouldn't have a problem with this, but we have a little teeny
laser in our office plugged into a 3kVa APC, and that UPS *still* trips
on-line when the printer comes out of sleep.
Surge suppressors are entirely another matter, but I would bet that
'They' meant UPSs.
--
Jay R. Ashworth Baylink jra at baylink.com
Designer The Things I Think RFC 2100
Ashworth & Associates http://baylink.pitas.com '87 e24
St Petersburg FL USA http://photo.imageinc.us +1 727 647 1274
More information about the Filepro-list
mailing list