new problem with FORM...(helllllp!!!) :)

[fp at casabellagallery.com]

Mark,

I have a couple of questions and suggestions

Q. How are you setting printer destination?
Q. Have you tried using "printer reset" & "close" commands?
Q. Have you tried setting output to a file and monitor target file grow?

S. Instead of running process as dclerk, run it as dreport 
   (dreport filename -f form -z source -v vsource -a -i___ )
   and replace your 'form' commands with 'print'.  Of course, you will
   need to use flags to know when to use 'form' or 'print'.  I normally
   check :if: @sn eq "":then:print:

I believe I came across something like this long ago and I think that 
using "printer reset" and/or "close" solved it.  Why?  Do not know!  

In the other hand, I normally send output to a file and then send file
to printer, just something I started doing some where along the way.

Regards,


Jose Lerebours