Setting Site Password and running FPCopy

Henry Melancon hemelancon at gifinc.com
Thu Oct 27 06:07:23 PDT 2005


Good morning, ladies and gentlemen.  I added the "@" to Set/Change Site
Password option on the Filepro Utilities Menu since it is the only
option that is not working.

This is what was displayed:

Interrupt 0DH, General Protection Fault    possible illegal address
error code = 0000

eax=00012e00
Ebx=FACD0005   etc......There is more of this part, but too much to type
unless it is really necessary to see.

Any suggestions?

Thanks,

Henry Melancon
Gulf Island, L.L..



-----Original Message-----
From: Kenneth Brody [mailto:kenbrody at bestweb.net] 
Sent: Wednesday, October 26, 2005 9:50 AM
To: Henry Melancon
Cc: filepro-list at seaslug.org
Subject: RE: Setting Site Password and running FPCopy

Quoting Henry Melancon (Wed, 26 Oct 2005 06:57:53 -0500):

> I did remove the normal line before adding the line you suggested.
> Something is happening, but the result is only flashed on the scene
and
> cannot be read.
[...]

Have you tried putting an "@" at the beginning of the menu command
line, to have filePro wait for Enter before returning to the menu?

--
KenBrody at BestWeb dot net        spamtrap:
<g8ymh8uf001 at sneakemail.com>
http://www.hvcomputer.com
http://www.fileProPlus.com


More information about the Filepro-list mailing list