filepro quirk

Roger Cornelius rac at custom-mobility.com
Fri Oct 29 11:48:14 PDT 2004


I want to say thanks to all who responded to my message.  This list is
obviously still quite active and even most of the same people that were
here two or so years ago are still here.

I was unable to find any mention in the filepro manual of this strange,
non-intuitive (my opinion) behavour of "eq".  Is it there somewhere?
Table 13.2 on page 13-32 of my Filepro 3.0 Reference Manual, which
describes the relationship codes, says EQ(or blank) means "equal to".  I
think I must have read about this on the list years ago and just
forgotten it because it seems so familiar.  I'll save the thread and
hopefully remember to refer back to it when needed.

Now I'll go post my other message.


More information about the Filepro-list mailing list