exists command - resolution

[Brian K. White]

----- Original Message ----- 
From: "Dennis Malen" <dmalen at malen.com>
To: "Brian K. White" <brian at aljex.com>; <filepro-list at lists.celestial.com>
Sent: Wednesday, December 08, 2004 2:17 PM
Subject: Fw: exists command - resolution


>
> ----- Original Message ----- 
> From: "Dennis Malen" <dmalen at malen.com>
> To: "Brian K. White" <brian at aljex.com>
> Sent: Wednesday, December 08, 2004 2:17 PM
> Subject: Re: exists command - resolution
>
>
>> Brian,
>>
>> Thanks again for your response.
>>
>> I may not be exporting properly based upon what Ken is saying.
>>
>> 1. I know I am exporting twice. I tried once to use the same export
>> definition which did not work. I defined two separate definitions to
> export
>> which did work.
>>
>> 2. Ken and you are saying I don't have to do that, but it works.
>>
>> 3. In reading Stuart Werner's book I see that he is not using the "write"
>> command. I am.
>>
>> 4. In the use of the "close" command perhaps I should not be using it
> before
>> I export twice or do I. Because I close the export in each export, this
> may
>> be causing the problem.
>>
>> The problem may be in my use of the "write" and "close" commands that are
>> causing the problem.

Again, referring to the example I posted, No write commands.

Brian K. White  --  brian at aljex.com  --  http://www.aljex.com/bkw/
+++++[>+++[>+++++>+++++++<<-]<-]>>+.>.+++++.+++++++.-.[>+<---]>++.
filePro BBx  Linux SCO  Prosper/FACTS AutoCAD  #callahans Satriani